EWAC Thermal Spray Powders

Product Main Features Typical Applicationso Hardness
EWAC 1001 EB Boron Carbide Deposits-Retains high hardness at elevated temperature. Resits galling, Scoring & Seizing Cams, Screws, Ceramic die cutters, Fan blades, Dies Tools etc. 55-62 HRC ( at 3mm thickness)
EWAC 1002ET Tungsten Carbide Deposits-Retains hardness at high temperature. Unequalled abrasion resistance & excellent edge retention Conveyor chains, Mixer paddles, Muller ploughs, Die frames, Tyre chains & mechanical seals 57-64 HRC ( at 3mm thickness)
EWAC 1003 EBZ Bronze Chrome Powder with low coefficient of friction, excellent machinability & superior toughness. Unlimited build up capability Shafts, Gears, Valve seats, Pumps feed rolls, Moulds, Splines, Rear axle tubes 36-42 HRC ( at 3mm thickness)
EWAC 1004 EN Universal use on Cast Iron, Good machinability, high resistance to impact, exhibits good tensile strength & ductility Engine Blocks, Exhaust manifold, Differential housings gears etc 80-100 Hrb ( at 3mm thickness)
EWAC 1005EC Deposits ideal for Build-up on Steel, SS & Ni alloys. Excellent corrosion resistance, ideal for joining, cladding & sealing Gears, Shafts, Pattern, Clutches, Templates & Keyways 80-100 Hrb ( at 3mm thickness)
EWAC 1006 EE Unique Cobalt based alloy formulation. Excellent corrosion resistance, outstanding abrasion, frictional resistance at elevated temperature Valves, Punches, Ingot tongs, Guide rolls, Wire drawing blocks, Charging rams, Valve spindles 43-45 HRC ( at 3mm thickness)
Product Range Main Features Typical Applications Technical Features
Proxon 21021 One step self-bonding alloy  Motors shafts, Steel mill rolls shafts Hardness-75 Hrb
  Alloy provides excellent toughness and corrosion resistance   Thickness-0.250"
  Property   Max Service Temp-540 Deg
Proxon 21022 General purpose Machinable self-bonding powder. Rotor shaft, Pump shaft, Gear box shaft spindles Hardness-80 Hrb
  Exceptional Frictional resistance. Recommended for   Thickness-0.250"
  bearing areas   Max Service Temp-650 Deg
Proxon 21031 Best alloy for resistance to erosion & cavitation.  Water turbine blades, Pump parts Hardness-72 Hrb
  Ideal for sliding friction &  corrosion resistance at high  turbine rotor Thickness-0.250"
  temperature   Max Service Temp-760 Deg
Proxon 21032S Self-bonding powder for corrosion & abrasion.  Gland pack areas, Oil seal area,  Hardness-30 HRC
  Coatings can be machined to ground finish Gear box shaft  Thickness-0.065"
      Max Service Temp-650 Deg
Proxon 21071 Aluminium -Bronze alloy for corrosion resistance coating.  Pump sleeves, Valve stem, Marine shaft, Propeller shaft & Journal areas Hardness-57 Hrb
  Tough deposits can be machined   Thickness-0.250"
      Max Service Temp-370 Deg